TCC-III LT/ST/RA
The TecsPak® pad inside diameter should easily slide onto the post inside the housing. There is a 1/32" clearance between the post diameter at bottom and the inside diameter of the pad. Therefore, if the clearance is greater than 1/32", the wrong pad has been applied. The top cap post should slide easily into the pad. With the TCC-III RA, install the base plate into the rectangular section of the housing with the writing facing up, then place the roller on it. The car body wear plate must cover the 3"-wide flat on the top cap.
Reference images below. Choose a TCC-III install option from the buttons below.
TCC-III LT/ST/RA
The TecsPak® pad inside diameter should easily slide onto the post inside the housing. There is a 1/32" clearance between the post diameter at bottom and the inside diameter of the pad. Therefore, if the clearance is greater than 1/32", the wrong pad has been applied. The top cap post should slide easily into the pad. With the TCC-III RA, install the base plate into the rectangular section of the housing with the writing facing up, then place the roller on it. The car body wear plate must cover the 3"-wide flat on the top cap.
Reference images below. Choose a TCC-III install option from the buttons below.